Engine is out, on its way to the machine shop today

[xrocket21]

Dropping it off at the machine shop today

[howling60]

woot!

glad to see headway being made james! too much to hope for to see you/facemelter @ limestone?

-Nate

[xrocket21]

im not holding my breath

[Rocwandrer]

im not holding my breath

drive something else? make someone else hold their breath until it is done to speed up the process? I'm sorry, but you just aren't allowed to miss limestone, man!

[picklesgarage]

maybe i missed something but why the pull?

[howling60]

im not holding my breath

james, if i thought it would survive a pair of people beating on it, i would offer co-drives on the corrado to ya (i know it's not nearly as fun... but it would be something)... heck.. bring your daily up.. if only to run SOMETHING...

I will hold *some* of my breath if it helps?

-Nate

[howling60]

maybe i missed something but why the pull?

I believe it was low compression rearing it's ugly head?

-Nate

[xrocket21]

maybe i missed something but why the pull?

low comp, oil consumption on a fully built shortblock with 30k miles

forged pistons, forged rods, moly coated rings, machined crank, race bearings, cosworth oil pump, arp studs, etc

[xrocket21]

im not holding my breath

drive something else? make someone else hold their breath until it is done to speed up the process? I'm sorry, but you just aren't allowed to miss limestone, man!

I wouldnt bother make the 1000 mile trip unless I had my car.

mapquest: 7 hours 41 minutes / 446.37 miles

I live almost in RI these days

[picklesgarage]

well its good then for it to be out and to a shop

[howling60]

well james, i'm feeling your pain (ish) in terms of attendance @ events... corrado is down because i tried to upgrade... and was sent the wrong parts... not happy... sooo.. the pseudo-offer of the corrado as a ride-along isn't really there anymore, sorry man.

-Nate

[xrocket21]

ahhh, thanks anyway man!